User`s guide

New Features
35-3
CAN FIFO Support
Use CAN FIFO model I/O drivers to either monitor an entire CAN network, or
to minimize driver latency for certain applications.
100 Mbit/Second Ethernet Support
Use 10 or 100 megabit/second communication between the host and target
computers for downloading real-time application and uploading signal data.
The communication uses the TCP/IP protocol with an Ethernet card in both the
host and target computers.
Fixed-Point Kernel Support
The xPC Target kernel runs on PCs (CPUs) that do not have a hardware
floating-point unit. If needed, xPC Target uses a software floating-point
emulator.
Increased Data Upload Speed
Upload log data about five times faster or better. Upload scope data about three
times faster.
I/O Device Driver Support
xPC Target 1.2 includes new device drivers blocks:
•New blocks to support additional I/O boards
•Blocks to support a GPIB fieldbus using a National Instruments GPIB
controller and an RS232 connection to the target PC
•Blocks to support CAN and CAN FIFO networks