User`s guide

Page 6
Page 11
5. Lower the ink cartridge clamps until they lock into place.
6. Close the printer cover.
7. Press the ink cartridge replacement
button. The printer moves the print head
and begins charging the ink delivery
system. This process takes about one
and a half minutes. While the ink is
charging, the power light flashes and
the printer produces a variety of
mechanical sounds. These sounds are
normal.
Caution:
q Do not turn the power off during the ink charging process.
q Do not load paper until ink charging is complete.
When the ink charging process is finished, the power light stops flashing
and remains on.
When ink cartridge installation is complete, proceed to “Load paper and
check the print head nozzles” below.
5
Load Paper & check the print head nozzles
Before checking the print head nozzles, you need to load paper as shown
below. When loading paper, make sure that the paper stack fits under
the tabs inside the edge guides and does not exceed the loading limit
indicated by the arrow mark on the left edge guide. To adjust the left edge
guide, hold down the locking tab and slide the guide against the paper stack.
Make sure that the position of the edge guide allows the paper to move up
and down freely.
locking tab left edge guide
printable side up
tab
output tray extension
1.
3. Remove only the yellow
tape from the ink
cartridges.
4. Position the tabs on each
ink cartridge so that they are resting
on top of the tabs protruding from the
base of the ink cartridge clamps. Do
not apply excessive force to the
cartridges.
Press the ink cartridge replacement
button. The print head moves out to the
cartridge change position.
7
Note:
Ink Cartridge Type:
Black: T026
Colour: T027
Changing the Ink Cartridges
Caution:
Do not move the print head by hand, as this may damage the printer.
2. Open the output tray and the printer cover, then lift up the ink catridge
clamps, as shown in the illustrations.
printer cover
output tray
ink cartridge clamps
Do not touch this part.
Note:
Install both cartridges.(if not already installed)
The printer will not work with only one cartridge.