User`s guide

Page 12
Page 5
8
4
User Information
3. Remove only the yellow
tape from the ink
cartridges.
4. Position the tabs on each
ink cartridge so that they are resting
on top of the tabs protruding from the
base of the ink cartridge clamps. Do
not apply excessive force to the
cartridges.
Note:
Ink Cartridge Type:
Black: T026
Colour: T027
Caution:
Do not move the print head by hand, as this may damage the printer.
2. Open the output tray and the printer cover, then lift up the ink catridge
clamps, as shown in the illustrations.
printer cover
output tray
ink cartridge clamps
Do not touch this part.
Note:
Install both cartridges. The printer will not work with only one
cartridge.
Install the ink cartridges
(if not already installed)
1. Make sure that the printer is turned on.
5. Lower the ink cartridge clamps until they lock into place.
6. Close the printer cover.
7. Press the ink cartridge replacement
button. The printer moves the print head
and begins charging the ink delivery
system. This process takes about one
and a half minutes. While the ink is
charging, the power light flashes and
the printer produces a variety of
mechanical sounds. These sounds are
normal.
Caution:
q Do not turn the power off during the ink charging process.
q Do not load paper until ink charging is complete.
When the ink charging process is finished, the power light stops flashing
and remains on.
When ink cartridge installation is complete, proceed to “Load paper and
check the print head nozzles” below.