User's Manual

Telemetry KIT MPYV2
User Manual and Maintenance
Document code: MPYV2-KMT.HL.MUM.001_ENG - rev. 1.1
Page 32 / 43
The copyright of this document is vested in Matipay S.r.l. - This document can not be reproduced in whole or in part, or stored in a
retrieval system, or transmitted in any form, or by any means without the prior permission of Matipay S.r.l.
Separate the internal electronic card (having P/N BI9150PMX, see [App.3]) from the back of the
casing; a situation like the one shown in Figure 19 is presented, with the backup battery to be
replaced in its seat. Remove it and replace it with the new backup battery.
At this point, reposition the electronic board inside the back shell of the casing, connect the
power cable of the new backup battery to connector J3 of the card and completely close the
MOD_HWT_INT module by hooking the tabs of the upper part of the casing.
Place the module inside the VM again and reconnect all the connectors. After making sure that
all the cables have been connected correctly, power the VM again.
BACKUP
BATTERY
BATTERY
SITE
Figure 19 – Backup Battery of MOD_HWT INT Module
The correct disposal of the exhausted battery helps to avoid any negative
consequences on the environment and health. For any additional information
relating to the recycling of the product, contact the municipality, the
ecological center office or the manufacturer.