User's Manual

Telemetry KIT MPYV2
User Manual and Maintenance
Document code: MPYV2-KMT.HL.MUM.001_ENG - rev. 1.1
Page 23 / 43
The copyright of this document is vested in Matipay S.r.l. - This document can not be reproduced in whole or in part, or stored in a
retrieval system, or transmitted in any form, or by any means without the prior permission of Matipay S.r.l.
The method of MOD_HWT_INT module fixing is at the discretion of the
installer. For this purpose, the use of cable ties is recommended.
It is strongly advised against the use of double-sided tape or products that
may lose adhesive capacity over time or due to temperature changes.
7.1.2 MOD_MPYV2_SPAY_C1 Installation
The Payment Module 2.0 MOD_MPYV2_SPAY_C1 is fixed to the VM front panel by using the
screws (code MVITEATFLAAD) supplied, according to the diagram shown in Figure 11.
The mounting height of the Payment Module with respect to the ground
must be less than 2 meters.
Since that the Payment module 2.0 MOD_MPYV2_SPAY_C1 is fixed to the front panel of the VM,
considering that it is not a "Mobile" type device, considering how it is used, it is implied that the
minimum distance of 20 cm between the module and the end user is intrinsically respected.
Figure 11 – MOD_MPYV2_SPAY_C1, mounting scheme.
Only if the MOD_MPYV2_SPAY_C1 module is used without the MOD_HWT_INT module, before
being installed, the CR2032 button battery must be inserted in the appropriate BT1 battery
holder, shown in Figure 1.
For the correct use and disposal of the CR2032 lithium battery, refer to the procedure indicated
in §8.