User's Manual

Telemetry KIT MPYV2
User Manual and Maintenance
Document code: MPYV2-KMT.HL.MUM.001_ENG - rev. 1.1
Page 20 / 43
The copyright of this document is vested in Matipay S.r.l. - This document can not be reproduced in whole or in part, or stored in a
retrieval system, or transmitted in any form, or by any means without the prior permission of Matipay S.r.l.
7 Preliminary operations and maintenance
7.1 Modules installation
The modules are intended exclusively for installation on Vending Machines equipped with an
MDB and EVA-DTS communication port. The MOD_HWT_INT Telemetry Module is installed inside
the VM while the Payment Module 2.0 MOD_MPYV2_SPAY_C1 is installed on the front of the VM.
Below are reported the mounting methods for each unit.
The modules can operate in a temperature range between -20°C to +50°C.
Before installing the modules, make sure that the main power source of
VM is disconnected.
7.1.1 MOD_HWT_INT Installation
In order to prevent damage to the module, precautions must be observed
before proceeding with installation to avoid the possibility of electrostatic
discharge (ESD).
For the first installation of MOD_HWT_INT module (see Figure 7) it is necessary to connect the
backup battery available inside the enclosure of MOD_HWT_INT module.
Please follows the here below procedure:
Figure 7 –MOD_HWT_INT Module