User's Manual

Telemetry KIT MPYV2
User Manual and Maintenance
Document code: MPYV2-KMT.HL.MUM.001_ENG - rev. 1.1
Page 13 / 43
The copyright of this document is vested in Matipay S.r.l. - This document can not be reproduced in whole or in part, or stored in a
retrieval system, or transmitted in any form, or by any means without the prior permission of Matipay S.r.l.
5 MOD_MPYV2_SPAY_C1 Description
The MATIPAY WI9250PM1 MOD_MPYV2_SPAY_C1 module, hereinafter also referred to as the
Payment Module, consists of an electronic card placed inside a plastic container with external
dimensions 105x84x19mm and overall weight less than 70g.
This module is mounted on the front panel of the VM and communicates with the MOD_HWT_INT
unit from which it also receives the supply voltage. Its task is to provide NFC connectivity (with
Smartphones and NFC cards like Mifare, Felica and Legic)
1
and Bluetooth LE to external devices
(such as Smartphones).
Only in the case of operation without the MOD_HWT_INT unit, the module can be equipped with
a CR2032 button battery to power the internal clock of the board in the event of a power failure.
This battery is not present in the Module in the basic configuration, but its use is intended for a
future application called "Standalone".
In Figure 3 the MOD_MPYV2_SPAY_C1 module is shown and in Table 4 the connector module is
described. In Table 5 the correspondence between ports/interfaces and connectors are detailed.
Figure 3 - MOD_MPYV2_SPAY_C1, front and rear view.
1
Compatibility with Mifare, Felica and Legic supports is strictly linked to the type of application loaded on the device.
Physical supports are always supported but could be tied to an application linked to the specific customer.