User's Manual

Telemetry KIT MPYV2
User Manual and Maintenance
Document code: MPYV2-KMT.HL.MUM.001_ENG - rev. 1.1
Page 12 / 43
The copyright of this document is vested in Matipay S.r.l. - This document can not be reproduced in whole or in part, or stored in a
retrieval system, or transmitted in any form, or by any means without the prior permission of Matipay S.r.l.
Item
Connector/Slot/Switch
Description
1
J2
External Connector for power supply input from VM
2
J3
Internal Connector for backup battery
3
J5
External Connector for GSM/GPRS antenna
4
J6
External Connector for MOD_MPYV2_SPAY_C1 connection
5
J7
External Connector for Future Use (I/O and Communication)
6
J9
External Connector for MDB/EVA DTS to VM connection
7
J10
External Slot for MicroSD HC insertion
8
SW2
External Switch for data upload from EVA DTS and module reset
9
U7
External Slot for SIM Card insertion
Table 2 – MOD_HWT_INT, connectors description, slots e switches.
The SW2 switch, available on MOD_HWT_INT, has a double functionality
depending on the pressure time:
- pressing from 2 to 9 seconds: EVA DTS data upload
- pressing more than 10 seconds: MOD_HWT_INT reboot
Item
Port/Interface
Q.ty
Conn.
Electrical
Characteristics
Connected to
1
Power Supply Input Voltage
1
J2
10Vdc - 40Vdc
VM
2
Power Supply Input Power
1
J2
<6W
VM
3
Antenna Interface
1
J5
COAX 50Ω
GSM/GPRS Antenna
4
Communication Interface to
MOD_MPYV2_SPAY_C1
1
J6
RS232
MOD_MPYV2_SPAY_C1
5
Power Supply Interface to
MOD_MPYV2_SPAY_C1
1
J6
5Vdc
MOD_MPYV2_SPAY_C1
6
I/O Interface
1
J7
Digital
Temperature Sensor and
auxiliary Relay available inside
VM
7
Communication Interface
2
J7
CAN
Future Use
8
Communication Interface
2
J9
EVA-DTS/MDB
Bus MDB/EVA DTS to VM
Table 3 – MOD_HWT_INT, ports/interfaces correspondence and connectors