Users Manual Part 2

73
There was a card jam.
Remove the cards by rotating the Ejection Dial, and press the SET
Key.
→See "When a Card is Jammed..." on page 75 for instructions on how to remove
car
ds.
Frequent card jams could mean the following:
Is the Transport Roller dirty?
Clean the Transport Roller.
If the Transport Roller is excessively dirty, continue cleaning using a
new Cleaning Card.
→See "Cleaning with a Cleaning Card" on page 56 for instructions on cleaning
the T
ransport Roller.
An error that requires repair may occur.
The cause of the error differs depending on the error code.
Turn off and on the power.
Repairs are necessary if the error reoccurs.
Program version update was interrupted.
Turn off and on the power, then start version update again.
Reading/writing of the magnetic data failed.
Press the SET Key.
Failure when reading/writing the magnetic data may mean the
following:
Is the card set in the correct direction?
Check the loading direction of the cards.
→See "Loading Cards" on page 10 for instructions on loading cards.
Are there any scratches or dirt on the card's magnetic strip?
Use undamaged cards.
Do the magnetic characteristics of the card match the
specifications of the magnetic encoder and the settings of the
magnetic encoder?
Check the specifications of the magnetic encoder.
→See "Checking the Program Version and Serial Number" on page 30 for
instructio
ns on how to check the specifications of the magnetic encoder.
During operation of the IC option 1, data reception by the computer
was interrupted.
Press the SET Key.
→Follow the directions of the application printing cards.
Error message
Cause and solution
Card Feed Remove
Card Turn Remove
Card Pr Remove
Card Mg Remove
Service Call
Download Error
Mg Write Error
Mg Read Error
IC1 Access Error
Operating Manual MC660
Matica Technologies