Specifications

Max imus
Cod e Reader PR OA
Max imus
Cod e Reader PR OA
MDMAXCRPROA MDMAXCRPROA
Page 4 2101026-16Page 3 2101026-16
Components & Controls Getting Started
Powering Up
Touch Screen
Setting Button
Home Button
Return Button
Diagnostic Cable
Memory Card Slot
(Reserved for future use)
Charging Port
The tool can receive power via either of the following ways:
Method 1: Via Diagnostic Cable
Connect the diagnostic cable of the tool to
the vehicle’s DLC (Data Link Connector) port.
*Note: The DLC is usually located 12 inches
from the center of the instrument panel
(dash), under or around the driver’s side for
most vehicles. See diagram for possible DLC
location.
Method 2: Via Data Cable
Connect one end of the included data cable to charging port of the tool, and
the other end to the PC.
The first time you use this tool, you will need to make some system settings
and keep the diagnostic software updated with the latest version.
Follow the steps below to proceed.
Now the tool is ready for use.
Tap “Start” on Welcome screen
Select system language
Select time zone
WLAN setup
Configure workshop information
Sign user agreement
Job Menu appears
Tap “Upgrade”
*Note: After completing this step,
the system will append it on the
report every time a report is
successfully generated.
*Note: To enjoy more capabilities
and better service, it is strongly
recommended to update the tool
on regular basis.
*Note: If you choose "Ignore" in
this step, it will go into the date
setting page. If the tool has been
properly connected to the
Internet, the system will
automatically obtain the correct
network date and time.
If you have any questions on the operation of the tool, please contact
Matco customer service number: 877-853-3738.
For more product information, please visit: www.matcotools.com