User`s manual

Preparing Your Printer for Printing Software Preparations for Printing
Sprinter User's Manual 8-15
Clicking OK will close the CONFIGURATION dialog box. So you may want to
set all the required configurations before clicking OK.
The procedures have been set out in the order that they appear in the
C
ONFIGURATION dialog box.
Selecting a Different Substrate Type and a Different Set of Head Delays
! To Select a Different Substrate Type and a Different Set of Head
Delays:
The type of S
UBSTRATE determines the HEAD DELAYS.
If you choose ‘No Delay’ in the Substrate box, all heads will start to print at
the same time.
• From the CONFIG drop-down list in the CONFIGURATION dialog box, select
the appropriate S
UBSTRATE.
The corresponding H
EAD settings appear in the HEAD DELAY box within
the C
ONFIGURATION dialog box.
Adding a New Substrate Type
! To Add a New Substrate type:
1. From the
CONFIGURATION dialog box, click Add.
The A
DD CONFIG dialog box appears (Figure 8-17).
Figure 8-17: The Add Config Dialog Box
2. In the CONFIG NAME field, enter the name of the new SUBSTRATE and
click OK.
3. Set the required delays in the corresponding D
ELAY and SHIFT spin
boxes.
When you add a new substrate name, it takes on the same delays as the
previous one.
4. Click OK to exit the dialog box.
If you want to add more than one new Substrate type, save each set of
delays between each addition, by choosing OK in the Configuration window.
The window will close. Open this window again and repeat the above
procedure for each new Substrate.