User`s manual

Preparing Your Printer for Printing Software Preparations for Printing
Sprinter User's Manual 8-13
14. Push back both the LOCKING PINS.
15. Relocate the S
UBSTRATE COLLECTING MECHANISM COVER by inserting it
into the two locating holes and gently pulling it downward.
Software Preparations for Printing
Using the Forward Icon
To advance the SUBSTRATE, click the FORWARD icon . This action
brings the printer to the unload status, raises the P
ULLING ARM, runs the
main motor as well as that of the S
UBSTRATE COLLECTOR ROLLER.
When you click the F
ORWARD icon, the following window appears.
To stop the S
UBSTRATE advancing, click OK.
Setting the Print Head Temperatures
During the printing process, the PRINT HEADS’ temperature will naturally
increase. This increase will be controlled by the settings made for the A
IR
COOLING unit (if installed).
Use W
ARM UP before you start a print run. Use COOL DN to reduce THE PRINT
HEAD temperatures to the required level before starting a new print run.
The temperature of the P
RINT HEADS is controlled through the COOL DN and
W
ARM UP icons.
! To warm up the Print Heads to the required temperature:
1. From the M
AIN SCREEN, click WARMUP.
The W
ARM UP. dialog box appears (Figure 8-14).
Figure 8-14: The Warm Up Dialog Box
2. Select the required temperature from the REQUIRED TEMPERATURE spin
box.
3. Activate the C
OOLING SYSTEM.
4. Click S
TART to initiate the process.