User`s manual

Preliminary Preparations for Printing Preparing Your Printer for Printing
8-6 Sprinter User's Manual
The Anti-static Brush and Strip that are located next to each Print Head, are
not shown in Figure 8-7, page 8-5.
16. When you reach the front end, pull the S
UBSTRATE until the entire width
has reached the front.
17. Close all the covers.
To replace the S
UBSTRATE, see the following procedures:
If possible, you should always try to leave an amount of Substrate under the
Print Heads so as to facilitate easy replacement or renewal.
! To replace the Substrate:
1. From the M
AIN SCREEN, click CONTROL.
The C
ONTROL PANEL dialog box appears (Figure 8-2, page 8-2).
- or -
From the U
TILITIES menu, select CONTROL PANEL.
The C
ONTROL PANEL dialog box appears.
2. Click U
NLOAD to lower all pistons and raise the PULLING ROLLER.
If the Ink Pistons are correctly positioned, their corresponding buttons in the
Control Panel will indicate ‘Down’ with a dotted frame around the word.
3. Take out the
STICKY CLEANING RUBBER ROLLER (the DUST COLLECTOR) by
pushing it left and pulling it out.
4. Wash it under the water tap, let it dry for a few minutes and relocate it.
5. Cut the old S
UBSTRATE as near as possible to the roll.
6. Remove the L
OCKING PIN from both the SUBSTRATE ROLL SUPPORTS.
(Figure 8-5, page 8-4).
7. Lift and remove the S
UBSTRATE ROLL from the SUBSTRATE ROLL SUPPORTS
and place it on a clean, flat surface.
8. Loosen the two R
ETAINING SCREWS and remove the right hand SUBSTRATE
RETAINER from the roll.
9. Remove the empty core and replace it with a new S
UBSTRATE ROLL.
Ensure that the new S
UBSTRATE ROLL is located in the middle of the BAR
that holds it.
10. Relocate the S
UBSTRATE RETAINER and tighten the two RETAINING
SCREWS.
11. Hold the S
UBSTRATE ROLL with the SUBSTRATE edge towards the printer.
12. With the split in the B
RAKE located at each end of the holders facing
upward, place the S
UBSTRATE ROLL back into SUBSTRATE ROLL SUPPORTS.