User`s manual

Sprinter User's Manual 8-1
8 Preparing Your Printer for Printing
Preliminary Preparations for Printing
This chapter sets out all the procedures necessary for preparing your
SprinterB Printer for work.
It deals with the setting up of the printer on the mechanical side. It also
sets out a detailed operating procedure for the exchanging or renewing of
S
UBSTRATES as well as the RIBBONS.
Once you have completed the following procedures, your SprinterB Printer
will be ready to use.
The Operating Procedures as set out in this manual should be followed in the
order that they are presented.
Figure 8-1: The Power Socket and Air Inlet
! To start up the printer:
1. Check that the air hose is connected.
2. Check that you have 4 Bar of air pressure on the A
IR PRESSURE GAUGE
for the 36” printer and 4.5 Bar for the 40” model.
3. Check that you have 220 VAC electric supply from the cable connected
to your power source.