User`s manual

The Utilities Menu Around the Windows
6-14 Sprinter User's Manual
The list below sets out all the settings you can make and describes the
various parts’ status you can read through the C
ONTROL PANEL dialog box.
Setting/Status Description
Substrate Sensor Indicates the status of the Substrate Sensor, as set in the
Configuration dialog box.
When there is no substrate present, an appropriate message
appears.
Pressure Sensor Indicates the status of the Pressure Sensor, as set in the
Preference dialog box.
When there is no pressure, an appropriate message appears.
Yellow/Magenta/Cyan/Black
Piston DOWN
To Raise and lower the relative color’s Piston.
…indicates that the head piston is up.
…indicates that the head piston is down.
All (1-4)
Click Press to raise all the Print Head Pistons.
Click Release to lower all the Print Head Pistons.
Substrate
…indicates that the Substrate Piston is up.
…indicates that the Substrate Piston is down.
Yellow/Magenta/Cyan/Black
Motor Run
Operate and stop the relative Ribbon Take-up Motor.
…indicates that the motor is idle.
…indicates that the motor is running.
Select the motor torque from the appropriate drop-down combo
box.
All (1-4)
Click Run to activate all the motors together.
Click Stop to stop all the motors.
Substrate
Run
Run or stop the Substrate Motor.
Select the motor speed from the appropriate drop-down combo
box.
Collector
Run
Run or stop the Collector Motor.
Select the motor torque from the appropriate drop-down combo
box.
The more Substrate on the Collector Roller, the higher the
required torque.
Cooling Door These option boxes appear only when you have checked the
Cooling System option in the Temperature Control group box
of the Configuration dialog box.
Check the required option box for continuous operation of the
TCS – without limits. Checking the fifth option box, will cause
the TCS to operate for all the Heads.