User`s manual

Air Compressor Specifications

Sprinter User's Manual 4-3

Air Compressor

5.5 Bar

Air supply flow rate

50 ltr/min

We recommend you to install an air dryer in addition to the air compressor and

locate it between the compressor and the printer.

We also recommend you to connect the air compressor and the air dryer to

separate phases from the printer.

Temperature Control System (TCS)

Cooling Capacity

16,000 BTU/Hr minimum for SprinterB 36”

20,000 BTU/Hr minimum for SprinterB 40”

Liquid Outlet Temp

15°C

Liquid

Motor cooling liquid (anti-freeze) – recommended, or water.

Flow Rate

5–10 GPM

LCS location

Indoor, 3–5m from the printer

Connection

Requirements

Inlet: flexible tube – 8mm outside dia, 6mm inside dia.

Outlet flexible tube – 8mm outside dia, 6mm inside dia.

We recommend that you consult with your local chiller provider for the above

requirements. Further information is available for example, at

http://www.liquidchillers.com.

Pneumatics

Air supply pressure

4 Bar (36”) 4.5 Bar (40”)

Air supply flow rate

50 ltr/min

Operating Conditions

Temperature

20°c-28°c (Room temperature)

Humidity

40% to 70% (Room humidity)