User`s manual

Packing & Transporting the SprinterB
VI Sprinter User's Manual
Appendix C: Packing & Transporting the
SprinterB
Whenever you have to move the printer to a new location, you must follow
the procedures as set out below.
Tools for packing:
Before you start packing the machine be sure that you have the following tools:
• Bubble nylon wrap (10 meters).
• Adhesive tape roll (1).
• Plastic bands (10).
• Long plastic bands, about 30 cm, or a rope (2m).
• Open key no. 22 or a wrench.
• Automatic screwdriver + 4 bits of Philips.
• 100 screws, 8 cms long.
• A set of Allen keys.
Packing the Printer
! To pack the printer:
• Check that the PCL is attached to the PC and P
LUG BOX CABINET.
• Bring all pistons down.
• Bring the substrate pulling-arm up.
• Place a sponge between it and the lower roller, and bring the arm down.
• Disconnect the system from the power and air supply.
• Disconnect the monitor from its cables.
• Remove the two Allen screws attaching the monitor stand to the printer.
• Pack the monitor in its original box.
• Disconnect and pack keyboard.
• Wrap the mouse and the monitor cables in nylon.
• Tighten all the P
RINT HEADS’ MOUNTING and TIGHTENING SCREWS.
• Clean the inside of the printer, including rubber rollers and all internal parts.
• Cut off any used substrate from the S
UBSTRATE COLLECTOR ROLL.
• Cover the ribbons, top and bottom, and underneath the P
RINT HEADS, with nylon.
• Clean the Sticky Roller with water. When it is dry, wrap it in nylon and relocate it on the
machine.
Packing should be done by an MDP representative or the distributor's representative.
Please check that you have a wooden box to pack the machine in.