User`s manual

Sprinter User's Manual 13-1
13 Installing & Configuring PhotoPRINT Server
This chapter sets out the procedures for installing and configuring the
Matan Edition of PhotoPRINT Server. This application is supplied with the
printer. You can, if you wish, use any RIP software application.
Installing the Software
The PhotoPRINT Server Key
PhotoPRINT will only run with a hardware key. The key protects
PhotoPRINT Server from being unlawfully copied and must be connected to
your computer whenever you use PhotoPRINT Server.
Installing the Key
! To install the key:
1. Turn off your computer.
2. Plug the hardware key into the AT parallel port (LPT1) on the back of
your computer.
If you need to plug a printer into this port, plug the PhotoPRINT Server
key into the port first. Then plug the printer into the key.
Installing PhotoPRINT Server
! To install the software on your computer:
1. Insert the PhotoPRINT Server CD into your CD-ROM drive.
The CD Setup will automatically appear within a few seconds.
If it does not appear, browse the CD using Explorer and launch
(double-click) AUTORUN.EXE.
2. From the CD S
ETUP window, select ENGLISH as the default and click
N
EXT.
The I
NSTALL OPTIONS dialog box appears.
3. Enter your U
SER NUMBER and PASSWORD (both appear on the hardware
key).
4. Click N
EXT.
The S
OFTWARE TO INSTALL dialog box appears.
5. Select the P
RODUCT and the LANGUAGE and click Next.
6. Follow the installation instructions that appear on the screen until you
are asked to restart the computer.
7. Restart the computer.