User`s manual

Maintenance Relocating the Printer
Sprinter User's Manual 10-5
Relocating the Printer
Care must be taken when relocating the printer. The following procedures
must be followed when relocating the printer at a place that is on the same
level as its original location.
If for any reason you have to relocate the printer at a place that is on a
different level from that at its original location, please contact Matan for
specific instructions.
 To relocate the printer:
1. Completely close down the printer and the PC.
2. Disconnect the power and air supplies from the P
OWER SOCKET and AIR
INLET PANEL.
3. Using an open spanner, raise the L
EVELING CASTOR'S four feet by
turning the orange nuts in a clockwise direction, so that all four wheels
are engaged (Figure 10-3) and the printer stands entirely on the four
wheels.
Wheel Engaged Wheel Disengaged
Figure 10-3: The Leveling Castor
4. Move the printer to the required location by pushing it from the rear.
Do not attempt to push the printer from the front side.
Do not attempt to pull the printer, from any side.
5. When the printer has been pushed to the required location, lower the
LEVELING CASTOR'S four feet by turning the orange nuts in an anti-
clockwise direction, so that all four wheels are just disengaged and the
printer stands entirely on the four feet.
6. Once the printer is relocated, it must be leveled before you start to use
it again.
7. Reconnect the power and air supplies from the P
OWER SOCKET and AIR
INLET PANEL, as well as the COOLER.
Wheel
Orange Nut
Foot