User`s manual

Scratch Prevention Procedures Maintenance
10-4 Sprinter User's Manual
• The PRINT HEADS should be cleaned with 100% alcohol, after 500m of
R
IBBONS have been used.
• The D
UST COLLECTOR should be cleaned daily with water and must be
replaced after using 5,000 meters of substrate, or after one year
(whichever occurs first).
• The printer should never be operated with the covers open.
• As an optional feature, the SprinterB software allows for a set of bars
about one-half inches wide to be printed across the whole web*, in all
four colors, between each print. If installed, this feature must be
activated (from the Configuration dialog box) and used at all times.
This feature allows you to inspect the print heads between each print
job and to detect any failure immediately. This facilitates your finding
the exact spot at which the print head failed. For further details on how
to handle a scratched P
RINT HEAD, see the Approved Substrate page on
our website. This ensures your proper documentation of and
compliance with the replacement program. The Damage Report Form
included at the end of this book, should be completed and returned to
Matan as well.
• The S
CRAPER should be engaged at all times when printing to brush off
any debris on the substrate
• A WEB is defined as any material in continuous flexible strip
form.
* A WEB is defined as any material in continuous flexible strip form.