User`s manual

Maintenance Cleaning the Dust Collector
Sprinter User's Manual 10-3
Cleaning the Dust Collector
The DUST COLLECTOR should be cleaned at the beginning of each day, as
well as when dust and dirt accumulates on the roll during production.
This prevents the dust and dirt from falling onto the substrate and thus
scratching the Print Heads, which in turn, reduces printing quality.
 To clean the Dust Collector:
• Remove the D
UST COLLECTOR from the printer, and wash it with clean
water and thoroughly dry it.
The Scraper
The SCRAPER is constantly applied to the SUBSTRATE. During substrate
loading, you must ensure that it is moved away from the S
UBSTRATE, to
allow the S
UBSTRATE to pass through.
You must clean the S
CRAPER whenever you clean the DUST COLLECTOR.
Figure 10-2: The Scraper
Scratch Prevention Procedures
• It is recommended to place The SprinterB printer on a pad of non-
static carpet.
• When loading and unloading S
UBSTRATE, you should never let the ends
of the substrate come in contact with the floor where dirt and particles
could be picked up. S
UBSTRATE should never be stored on the floor and
should always be placed in the bag in which it was delivered.
• S
UBSTRATE should never be pulled back through the printer. It should
only pass under the
PRINT HEADS once.
• Only Matan’s approved substrate should be used in the SprinterB
printer.