User guide

Temperature Controller iB6 / iB12

Precautions

Use of this equipment in a manner not specified by the manufacturer

may impair protection provided by the equipment.

In addition to presenting a potential fire hazard, high voltage and high

temperature can damage equipment and cause severe injury or death.

When installing or using this instrument, follow all instructions carefully

and use approved safety controls.

Hazardous potentials exist on components inside the controller. Always

disconnect AC power to the mainframe when servicing the controller.

Because these temperature controls or associated equipment may not

always fail safe, an approved temperature and/or pressure safety control

should be used for safe operation.

Turn off power to the controller before cleaning the exterior of the

controller.

Failure to observe these precautions can result in exposure to a

potentially lethal shock hazard.

All wiring should be done by an experienced technician. The controller

and wiring should be installed in accordance with national and local

electrical codes. To avoid serious personal injury and damage to

equipment, follow all warnings and cautions provided in the hardware

setup instructions.

WARNING

1.0 Introduction

If a controller shows signs of having been damaged during shipping, do

not power up or install the controller. Save all packing materials and

report any damage to the carrier immediately.

Do not locate this instrument where it may be subjected to excessive

shock, vibration, dirt, moisture, oil, or other liquids.

This is a Class A product. In domestic environment this product may

cause radio interference in which case the user may be required to take

adequate measures.

Specified operating ambient temperature is 0 to 50 °C (32 to 122 °F).

CAUTION