User guide

© Copyright Mastip Technology Limited. Information subject to alteration. V1.02 www.mastip.com
28
Temperature ControlleriB6 / iB12
Name Applies to Range/
Choices
Default Description & Interactions
Selected Zones All Zones Closed Loop Control Open Loop Control
Soft Start
 
Disable
Enable
Enable Gradual increase of output to
slowly dissipate moisture in
heaters; refer to 1.2.3
Mode Key
Enable
  
Disable
Enable
Enable
Enables/disables button
Boost Key
Enable
  
Disable
Enable
Enable
Enables/disables button
SP Change
Enable
  
Disable
Enable
Enable Enables/disables use of front
panel buttons to change Normal
mode setpoint and Manual mode
output percentage
Config.
Enable
  
Disable
Enable
Enable Enables/disables use of front
panel buttons to change
configuration parameter values
Reset PID
Parameters
 
Yes
No
No Return tuning parameters to
their default settings, undoing
Autotuning or manual tuning
Load Defaults
  
Yes
No
No Return configuration parameter
values to their default settings as
described in Section 8.0
5.0 Parameter Characteristics
Typical Autotune PV Profile
SV
Heat Storage Test
Heat On
Heat On
Heat Off
Response Test
Starting Conditions Test
5.7.2 Supervisor Parameters and Settings