User guide

Temperature Controller iB6 / iB12
© Copyright Mastip Technology Limited. Information subject to alteration. V1.02 www.mastip.com
21
5.3 Boost Parameters
5.3.1 Introduction
A boost button s on the iB6 and iB12 front panel. When you press , the output of a zones will
be increased temporarily.
You can use the Boost Config menu to specify:
• whether the boost function will be closed loop (based on a setpoint) or open loop (based on a
specified output percent)
• boost setpoint and duration for closed loop boost
• boost output percentage and duration for open loop boost
5.3.2 Boost Parameters and Settings
5.0 Parameter Characteristics
Name Applies to Range/
Choices
Default Description & Interactions
Selected Zones All Zones Closed Loop Control Open Loop Control
Boost Type
 
Open Loop
Closed Loop
Closed Loop
Type of control used after is
pressed; applies only to zones
running in Normal mode; zones
running in Manual mode always
use Closed Loop boost
Boost
Duration
  
Boost Off
15 seconds
30 seconds
45 seconds
60 seconds
75 seconds
90 seconds
105 seconds
120 seconds
Boost Off Length of boost
Boost
Setpoint
 
Low Setpoint
Limit to High
Setpoint
Limit (from
Input Config
menu)
25 °C
77 °F
Setpoint used in Closed Loop
boost
Boost
Percentage
 
0 to 100% 0 (off) Output percent used in Open
Loop boost