User guide

Temperature Controller iB6 / iB12

3.0 User Interface

Menu Parameters Factory Setting

Display

Config

Display Units °C

Alarm

Config

Inhibit Seconds 0 (off)

High Dev Setpoint [High Deviation] 17 °C (30 °F)

Low Dev Setpoint [Low Deviation] 17 °C (30 °F)

Alarm Silence Seconds 120 seconds—applies to all zones

Superv.

Config

[Supervisor]

Set Superv. Password 100 = OFF (password protection

disabled) - applies to all zones

Fail Safe Action Auto Average (use a calculated

output value based on output values

that have typically successfully

maintained the current setpoint

for your process in the past; if no

history of Normal mode operation,

then output is set to zero) - applies

to selected zone

Low Reading Not applicable

High Reading Not applicable

High [Temperature] Safety [Limit] OFF - applies to selected zone

Fail Safe FOP [Fixed Output

Percent]

0 % - applies to selected zone

Loop Break Time 300 seconds - applies to selected zone

Soft Start (CompuStep® gradual

warming)

Enable - applies to all zones that

are in Normal (closed loop) mode

Mode Key Enable Enable - applies to all zones

Boost Key Enable Enable - applies to all zones

SP [Setpoint] Change Enable Enable - applies to all zones

Config. Enable Enable - applies to all zones

Reset PID Parameters No - applies to selected zone

Load Defaults No - applies to selected zone (but all

zones must be in Idle; changes take

effect after power has been cycled)

Supplied as °F if sold in USA or when requested at time of purchase