User guide

Temperature Controller iB6 / iB12
© Copyright Mastip Technology Limited. Information subject to alteration. V1.02 www.mastip.com
13
3.2.2 Button Functions
Buttons provide access to all controller functions
3
. The purposes of the buttons are shown below.
³ The Superv [Supervisor] Config menu can be used to disable the Boost and mode buttons, and to prevent operators from changing
the setpoint or configuration parameter values.
3.0 User Interface
3.2 LED Status and Button Functions
3.2.1 LED Symbols
A column of LEDs for each zone indicates statuses for the zone and its output.
LED Description LED Description
Output: lit green when the zones output
is on
Open Loop: lit green when the zone is in
an open loop mode, such as Manual or
Open Loop Boost
Boost: lit green when the zone is in
Boost mode
Standby: lit green when the zone is in an
standby mode or Hardware Standby mode
Closed Loop: lit green when the zone is
in a closed loop mode, such as Normal,
Closed Loop Boost, Normal Soft Start,
etc.
Alarm: flashes red when the zone is in
alarm
For more information about alarm
indications, see Section 4.2.
Button Description Button Description
Select one zone or all zones Increase setpoint for the selected
zone(s) and change parameter
values
Silence alarms for a configurable
number of seconds
Decrease setpoint for the selected
zone(s) and change parameter
values
Boost all zones Change the mode for the selected
zone(s) and step through menu tems
Press briefly to put all idle zones in
run state; press at least two seonds
to put all zones in idle
Brief press to display modes of all
zones; longer presses to enter menu
system and then brief press to step
through menus
Zone
Increase
Decrease
Mode
Menu
Mute
Boost
Idle