User guide

© Copyright Mastip Technology Limited. Information subject to alteration. V1.02 www.mastip.com
12
Temperature ControlleriB6 / iB123.0 User Interface
for Manual (closed loop)
for Standby
If the zone is configured to start up in Idle after the run/idle button has been pressed, no
status LED will be lit.
Whenever a zones output is on, its green output LED is lit.
3.1 Overview
During operation, the front panel contains a two-line display that displays the PV (process value) and
SP (Normal (closed loop) mode setpoint or Manual (open loop) mode output percentage) for each
zone during normal operation. Zone numbers are under the display. PV and SP values are displayed
in the unit of measure (degrees C or degrees F) indicated by the lit green “C” or “F” LED.
This display can also be used to view and change controller settings as described in subsection 3.5.
Parameters are grouped into menus. An overview of the menus is in subsection 3.6
If a zone is in alarm, an alarm code alternates with the SP value.
Alarm codes and priorities are listed in Section 4.5
PV
SP
PV
SP
285
60%
251
250
250
250
250
250
252
250
250
249
285
60%
251
250
250
250
250
250
252
250
250
249
PV
SP
1 2 3 4 5 6 F C
285
60%
251
250
250
250
250
250
252
250
250
249
iB6 Operating Display
iB12 Operating Display