Product Manual

14
ENGLISH
Remote control terminal (optional)
The remote control terminal offers two functions:
• Alarm contact (dry contact)
The alarm contact switches when a fault occurs.
• Remote switch
Install a switch for remote operation. Make sure the main switch is at “REMOTE” position.
Alarm contact (maximum load 30 V / 1 A)
1 Normally Open (NO)
2 Common
3 Normally Closed (NC)
Remote control
4
Enable  (ENB)
5
Enable  (ENB)
6
Ground (GND)
(same polarity with negative battery input)
7. Configuration
DIP switch functions
1 Output voltage selection
2 Output voltage selection
3 Output frequency selection
4 Power saving mode ON/OFF
Output voltage selection
Output voltage DIP switch 1 DIP switch 2
200 V / 100 V OFF OFF
220 V / 110 V ON OFF
230 V / 115 V OFF ON
240 V / 120 V ON ON