MASTERSOUND M a s t e r E m o t i o n Evolution 845 Made in Italy
Our Philosophy Our philosophy is simple: we want to produce amplifiers which stimulate the emotions for those who enjoy music. We believe that every piece of music played through our amplifiers should arouse in the listener the same emotions as the artist who composed it and the musician who interpreted it.
Mastersound story MasterSound is an Italian company which has produced, for the past 15 years, class “A”, tube amplifiers. Our most important priority is to build equipment of the highest quality. We give the highest attention to quality in our design, our components, and our construction. Each part of our amplifier has been hand built with passion and skill. Our attention to detail will guarantee years and years of trouble free listening.
Integrated Amplifier Evolution 845 Evolution 845 is the culmination of the collective knowledge and experience The of all those who work with MasterSound. The total absence of feedback makes the truly amazing. Evolution 845 fast, with imaging that is Evolution 845 Our new, dual drive control system of the pre-amp section grew from our careful research.
Inside We built the Evolution 845 with the utmost care, using only selected materials. Our product passed the stricter quality tests with excellent results and is now ready to offer You many years of pleasant listening. A new amplifier needs to be put on at low volume in order to perform at its best the musicality and high definition of sound.
Tubes installation During the transportation the tubes are kept in an appropriate box and then they must be placed in the correct position (see the photo above). The 845 tube is indicated either by letter A, B, C, D which stand between the pins and are written on the base: that is the right place for the tube to be installed.
Rear view 1. The bias control input. 2. Holder containing a plug with incorporated fuse. 3. Six speakers connectors :two with black rings and four with red rings (8-4 ohms). 4. RCA connector for the inputs 5. Our logo label with the serial number.
Check list To be done by the dealer: set up the amplifier with the right impedance 4/8 ohm suitable for the speakers and select the right main line according to country. The above checks are to be made inside the amplifier and shall be carried out only by qualified staff. To be done by the Purchaser: • Place the amplifier on a solid and flat surface. • Place the tubes in their correct socket positions.
Switching on of the amplifier A red led flashing lights, which should go on when You switch on the amplifier, indicating the correct functioning. When the inner tensions have reached the correct level, while the red led light grows bright, the Evolution 845 is ready to work.
Last recommendations Any change of interconnectors (cables, etc...) must be done with the amplifier switched in the off position. Never move or remove the amplifier when tubes are still hot. Never install or remove tubes when the amplifier is still switched in the on position. Maintenance of the amplifier Use gently a wet and soft cloth (buckskin) to clean Your amplifier and dry immediately. Never clean Your amplifier when hot or running.
Specifications • Integrated tube amplifier dual mono • Parallel Single Ended in Classe “A” • A selected quartet out tubes triode 845 • Pre-driver selected tubes 2 x ECC 82 • Driver selected tubes 2 x 6SN7 EH • Power output 55 Watts /Channel • Inputs: 3 x Line + 1 Direct • Input sensitivity 1 Volt • Input impedance 100 K Ohm • Load impedance 4 - 8 Ohm • Output transformer Mastersound • Negative feedback “non-existent” 0 db • Frequency 8 Hz / 40 Khz – 0 db • Dimensions 54 x 47 x 27
Warranty Evolution 845 Your , except the tubes, comes with a five years limited warranty covering defects in material and craftsmanship. During the warranty period, repairs are provided free of charge. Transportation costs and from the repair provider has to be paid by the owner. This warranty is void when: • the serial numbers have been removed • the screws fixed to the underside, have been removed • other kind of tubes different from the original have been used.
