MASTERSOUND M a s t e r E m o t i o n Due Trenta S.E.
Our Philosophy Our philosophy is simple: we want to produce amplifiers which stimulate the emotions for those who enjoy music. We believe that every piece of music played through our amplifiers should arouse in the listener the same emotions as the artist who composed it and the musician who interpreted it.
Mastersound story Master Sound is an Italian company which has produced, for the past 18 years, class “A”, tube amplifiers. Our most important priority is to build equipment of the highest quality. We give the highest attention to quality in our design, our components, and our construction. Each part of our amplifier has been hand built with passion and skill. Our attention to detail will guarantee years and years of trouble free listening.
Integrated Amplifier Due Trenta S.E. Congratulations on your choice! The model Due Trenta S.E. that You chose is a integrated amplifier in pure class “A” which enhances the technical evolution of the classic KT88. The output transformer we designed and manufactured for this pentode allows to reach a range of extension which would be otherwise impossible with standard output transformers which need work with a negative reaction. The result is a perfect sound stage and a surprising presence.
Inside We built the Due Trenta S.E. model with the utmost care, using only selected materials. Our product passed the stricter quality tests with excellent results and is now ready to offer You many years of pleasant listening. A new amplifier needs to be put on at low volume in order to perform at its best the musicality and high definition of sound.
Tubes installation (If not already installs) During the transportation the tubes are kept in an appropriate box and then they must be placed in the correct position (see the photo above). The KT88 tube is indicated either by letter A , B ecc., which stand between the pins and are written on the base: that is the right place for the tube to be installed.
Rear view 1. Holder containing a plug with incorporated fuse. 2. Six speakers connectors: two with black rings and four with red rings (8-4 ohms). 3. Eight RCA connector for the inputs line 4.
Check list To be done by the dealer: set up the amplifier with the right impedance 4/8 ohm suitable for the speakers and select the right main line according to country. The above checks are to be made inside the amplifier and shall be carried out only by qualified staff. To be done by the Purchaser: 8 • Place the amplifier on a solid and flat surface. • Place the tubes in their correct socket positions.
Switching on of the amplifier On the front panel of the amplifier there are some red lights, which light up when You switch on the amplifier to indicate the correct functioning. The amplifier must be pre-heated at least for twenty minutes, to reach the right temperature so as to get the best results in listening. The cylinders of the transformer have the function of heat sinks of the system, so it's normal that they reach a certain temperature during the listening sessions.
Maintenance of the amplifier Avoid extremely hot locations such as near radiators, stove or other heating units. Use gently a wet and soft cloth (buckskin) to clean Your amplifier and dry immediately. Never clean Your amplifier when hot or running. Do not forget to take out the plugs before starting to clean the amplifier. .
Specifications • Integrated tube amplifier • Parallel Single Ended in Classe “A” • A selected quartet • Driver selected tubes 2 x ECC 802 • Power output • Inputs: 4 x Line • Input sensitivity 1 Volt • Input impedance 50 K Ohm • Load impedance 4 - 8 Ohm • Output transformer Mastersound • Negative feedback “non-existent” 0 db • Frequency 15 Hz / 30 Khz – 0 db • Volume with remote control (Optional) • Dimensions 47 x 20 x 33 cm.
Warranty Your Due Trenta S.E. , except the tubes, comes with a five years limited warranty covering defects in material and craftsmanship. During the warranty period, repairs are provided free of charge. Transportation costs and from the repair provider has to be paid by the owner. This warranty is void when: • the serial numbers have been removed • the screws fixed to the underside, have been removed • other kind of tubes different from the original have been used.
