Use Instructions

Page 17/233
MasterScope - Instructions for Use
Version 03.00 • Date 19FEB2020
2. Turning on the MasterScope
Connect your MasterScope to a power socket which corresponds to the local
regulations (110/240V). Turn the MasterScope ON using the power switch on the
keyboard.
2.1 Login
The identification of the current user is necessary during startup and before each
measurement.
For further information, see chapter “Program Access”.
Running system on power supply
If the MasterScope is not connected to the power supply while in use, a warning
message is displayed on top of the screen. Please make sure that the power cable
is connected to the MasterScope.
Do not use the notebook without connecting it to the power supply since it could
lead to loss of data. Never do a measurement without connection to the power
supply. The MasterScope should be shut down at the end of each visit day, while
keeping it connected to the power supply. The MasterScope must be connected
to the power supply and turned on at least once a month for a minimum of 24
hours. This is to keep the battery charged and to save essential settings of the
notebook, e.g. date and time.
The notebook is protected by a power-on password, which will be distributed by
ERT during the training session.
After turning on the MasterScope, please wait for about 5 minutes
before starting the first measurement.
In case the MasterScope is not in use for longer than 12 hrs the system
will shut down automatically. This is to avoid any damage on the hard
disk.