Use Instructions

Page 62/233
MasterScope - Instructions for Use
Version 03.00 • Date 19FEB2020
5. Program Access
System access to the MasterScope requires fingerprint identification.
Your CRA and/or a representative of ERT will perform this registration at the
training or during an onsite visit. The identification of the current user is necessary
during start-up and before each measurement.
5.1 Fingerprint Identification
To log in using the fingerprinting sensor, follow
these steps:
1. Choose whether you would like to work
in Subject Mode, Proficiency Mode or
Training Mode (details see chapter “Subject,
Proficiency and Training Mode”).
2. Place your registered finger flat and centered
on the sensor, using moderate pressure.
3. The system will look for a match of your
fingerprint against the one registered under
your user name.
4. Your user name is shown on the screen.
5. If the User Name is correct, place your finger a
second time on the sensor.
6. The system will verify your fingerprint.
7. The dialog box disappears.
The following window appears:
If the fingerprint identification device fails to recognize the fingerprint of a
registered user, you may also use the “Temporary Password” tab to gain
access (see chapter “Temporary Password”).