Use Instructions

Page 188/233
MasterScope - Instructions for Use
Version 03.00 • Date 19FEB2020
15. MasterScope Software Updates
15.1 Online Update
Everytime when the MasterScope transmits the data to the data center, it will
automatically check if there are any new software updates available. If so,
the update(s) will be downloaded automatically after the data transfer. Once
downloaded the new update(s) can be installed.
There are two different updates possible to receive:
• software update for protocol configuration, e.g. protocol amendment
• windows component update, e.g. daylight saving changes in a specific country
Available updates are
listed here separated
by protocol update
or windows update.
By selecting an
update, a respective
“Release Note” will be
displayed with detailed
information about the
update.
Click <Install Now> to start the installation.
Click <Cancel> to install the update later.
Updates should be installed immediately after downloading. If you have
ongoing subject visits, make sure to install the update(s) after the patient visits
are completed for that particular day.
Online Update will not be supported with the SD Card Upload transfer
methodology. If you are using this methodology either switch to another
methodology e.g. WLAN or contact ERT Customer Care to receive the new
software update on a SD Media card via mail.