Use And Care Manual

Page 16
INSTALLING & CLEANING CARTRIDGE FILTER
Installing Cartridge Filter
1. Verify that the power cord is disconnected
from the outlet. (fig. 1)
Fig. 1
2. Remove power head and place in upside
down position.
3. Install the cartridge filter over the filter cage
and carefully push filter in until it stops
against the power head. (fig. 2 & 3)
Fig. 2 Fig. 3
4. Place filter retainer on top of cartridge
filter and tighten down by turning retainer
clockwise. (fig. 4 & 5)
Fig. 4 Fig. 5
Removing and Cleaning Cartridge Filter
1. Unlock and remove the filter retainer by
turning retainer handle counter clockwise.
2. Carefully hold and pull the cartridge filter up
for removal. (fig. 6)
Fig. 6
3. Clean the cartridge filter by gently tapping
or brushing dirt off. Cleaning should not be
done indoors in living areas. For optimal
performance a new filter is recommended.