Use And Care Manual

Page 7
GENERAL ASSEMBLY INSTRUCTIONS
WARNING:
DO NOT PLUG POWER
CORD INTO POWER OUTLET. MAKE
SURE PLUG IS DISCONNECTED BEFORE
ASSEMBLING THE WET/DRY VACUUM.
UNPACKING YOUR WET/DRY VACUUM &
GENERAL ASSEMBLY
1. Verify that the power cord is disconnected
from the outlet. (fig. 1)
Fig. 1
2. Undo the latches. (fig. 2)
Fig. 2
1
2
3. Lift the power head off the collection tank.
(fig. 3)
Fig. 3
4. Remove the contents from inside the
collection tank. Make sure you have all
contents as listed on page 5. (fig. 4)
Fig. 4
5. Turn the collection tank upside down and
insert the four caster feet into the slots on
the collection tank and tighten with supplied
screws. Verify that the casters are mounted
correctly. Do not over-tighten screws. (fig. 5)
Fig. 5
6. Your vacuum comes ready for dry vacuum
cleaning. For filter installation instructions,
see page 16. (fig. 6 & 7)
Fig. 6 Fig. 7