Use And Care Manual

ManualsBrandsMasterforce ManualsTools8 Gallon 4.5 Peak HP Wet/Dry Shop Vacuum with Detachable Blower

Page 15

MAINTENANCE

BLOWER INTAKE

WARNING:

ALWAYS DISCONNECT

THE PLUG FROM THE POWER OUTLET

BEFORE REMOVING THE POWER HEAD

FROM THE COLLECTION TANK.

After using the blower, examine the bottom

of the blower for debris and blockages and

remove if found. To clean the foam pad of the

intake:

1. Verify that the power cord is disconnected

from the outlet. (fig. 1)

Fig. 1

2. Remove the four screws holding the intake

shield and lift off the shield. (fig. 2)

Fig. 2

3. Remove the foam pad from the blower and

clean the foam pad with soapy water and

allow to dry. (fig. 3)

Fig. 3

4. Check the foam pad for reuse. If you need

to replace the foam pad consult the parts

list of the manual.

5. Replace the foam pad onto the blower

aligning the holes to the screw tabs. (fig. 4)

Fig. 4

6. Reinstall the intake shield and the four

screws. (fig. 5)

Fig. 5