Use And Care Manual

Page 9
DRY VACUUMING
WARNING:
BE SURE TO READ,
UNDERSTAND, AND APPLY INFORMATION,
ENTITLED ‘SAFETY INSTRUCTIONS &
WARNINGS’. DO NOT VACUUM IN AREAS
WITH FLAMMABLE GASES, VAPORS, OR
EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE
GASES OR VAPORS INCLUDE BUT ARE NOT
LIMITED TO: LIGHTER FLUID, SOLVENT TYPE
CLEANERS, OIL-BASED PAINTS, GASOLINE,
ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE
DUSTS INCLUDE BUT ARE NOT LIMITED
TO: COAL, MAGNESIUM, GRAIN OR GUN
POWDER. TO REDUCE THE RISK OF HEALTH
HAZARDS FROM VAPORS OR DUST, DO NOT
VACUUM TOXIC MATERIALS.
WARNING:
DO NOT PLUG POWER
CORD INTO POWER OUTLET. MAKE SURE
PLUG IS DISCONNECTED BEFORE CHANGING
OR CLEANING FILTERS.
1. Verify that the power cord is disconnected
from the outlet. (fig. 1)
Fig. 1
2. In order to prepare your vacuum for dry
vacuuming, verify that the cartridge filter
is securely installed. Make sure the filter is
pushed in until it stops against the power
head. (fig. 2) (Your Wet/Dry Vac comes
with the cartridge filter pre-installed, if not
see page 16 for installation instructions.)
Fig. 2
3. Place filter retainer on top of cartridge filter
and tighten down by turning the retainer
handle clockwise. (fig. 3)
Fig. 3
4. Place the power head back on the collection
tank, aligning the top section with the
latches, and snap into place. (fig. 4)
Fig. 4
DRY VACUUM OPERATION