Use And Care Manual

WARNING:
WARNING:
Page 3
GENERAL SAFETY RULES
INSPECTION
1. Inspect the jack carefully before each use. Ensure the jack is not damaged, excessively worn,
or missing parts.
2. Do not use the jack unless it is properly lubricated.
3. Using a jack that is not in good clean working condition or properly lubricated may cause serious
injury.
4. Inspect the work area before each use. Make sure it is free and clear of any potential hazards.
DO NOT OPERATE OR REPAIR THIS EQUIPMENT WITHOUT READING THIS MANUAL.
To maintain the Service Jack and user safety, the responsibility of the owner is to read and follow
these instructions.
1. Inspect the service jack for proper operation and function.
2. Keep instructions readily available for equipment operators.
3. Make certain all equipment operators are properly trained; understand how to safely and
correctly operate the unit.
4. Allow unit operation only with all parts in place and operating properly.
5. Use only genuine replacement parts.
6. Service and maintain the unit only with authorized or approved replacement parts; negligence
will make the jack unsafe for use and void the warranty.
7. Carefully inspect the unit on a regular basis and perform all maintenance as required.
8. Store these instructions in the handle of your jack.
9. Keep all decals on the unit clean and visible.
Read and understand all instructions. Failure to follow all instructions
listed below may result in serious injury.
CAUTION:
Do not allow persons to operate or assemble this jack until they have read
this manual and have developed a thorough understanding of how the jack works.
The warnings, cautions and instructions discussed in this instruction
manual cannot cover all possible conditions or situations that could occur. It must be
understood by the operator that common sense and caution are factors that cannot be built into
this equipment, but must be supplied by the operator.
IMPORTANT SAFETY CONSIDERATIONS