Use And Care Manual

Page 6
OPERATION INSTRUCTIONS
• If the operator is not fluent in English, the
product and safety instructions shall be read
to and discussed with the operator in the
operator's native language by the
purchaser/owner or his designee, making sure
that the operator comprehends their contents.
• Visual inspection shall be performed before
each use of the stand by checking abnormal
condition, such as cracked welds, leaks and
damaged, loose, or missing parts if stand is
believed to have been subjected to abnormal
load or shock inspection shall be made by
authorized repair facility.
• Equipment that appears damage or worn or
operates abnormally shall be removed from
service.
TO LOWER LOAD
1. Ensure that all tools, equipment and
personnel are clear before lowering load.
2. With suitable jack, raise vehicle clear of
stands.
3. Carefully release stopper and allow ratchet
to glide down to lowest position.
4. Carefully remove stands, then carefully
lower vehicle with lifting device.
1. Use on hard level surface with less than 3
degrees of slope.
2. Raise vehicle with suitable jack.
3. Adjust height by pulling up on ratchet bar.
4. The weight of the locking handle should
secure the ratchet bar in desired position. To
confirm this, simply push down on the locking
handle. Check to ensure ratchet is secure
before loading.
5. Carefully position jack stands so that load is
centered on stand’s saddle.
6. Slowly lower the vehicle onto the stands.
7. Check to ensure vehicle is secure before
working on, around or under. When used to
support vehicle, use wheel chocks on all
unlifted wheels in both directions to prevent
inadvertent movement.
8. DO NOT jack or dolley while jack stands are
supporting the vehicle.