3 Ton Jack Stands with Double Lock 260-2001 OPERATOR’S MANUAL CAUTION: To Reduce The Risk Of Injury, User Must Read And Understand Operator’s Manual. Save These Instructions For Future Reference.
TABLE OF CONTENTS Safety Symbols ...................................................................................Page 2 Intended Use........................................................................................Page 2 Technical Specifications.....................................................................Page 2 General Safety Rules...........................................................................Page 3 Safety Markings.................................................................
SAFETY SYMBOLS Some of the following symbols may be used on your tool. Please study them and learn their meaning. proper interpretation of these symbols will allow you to operate the tool better and safer.
GENERAL SAFETY RULES WARNING: Read and understand all instructions. Failure to follow all instructions listed below may result in serious injury. CAUTION: Do not allow persons to operate or assemble this jack until they have read this manual and have developed a thorough understanding of how the jack works. WARNING: The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions or situations that could occur.
SAFETY MARKINGS WARNING: 1. Study, understand, and follow all instructions before operating this device. 2. Do not exceed rated capacity. 3. Use only on hard, level surfaces, with less than 3 degrees of slope. 4. Center load on saddle. 5. Use as a matched pair only. 6. Stands are not to be used to simultaneously support both ends of a vehicle. 7. No alterations shall be made to this product. 8. Support only on areas of the vehicle as specified by the vehicle manufacturer. 9.
ASSEMBLY INSTRUCTIONS In order to prevent removal of the post from the base use a hammer and flat end punch to hammer the jack's tab in toward to post but not touching the post. Same stands are equipped with a bolt instead of the tab. In this case the bolt can be threaded in toward the post until the bolt bottoms out. 1. Install ratchet bar into frame (FIG.1) with ratchet portion of bar aligned with locking pawl (stopper). FIG. 1 3. Bend metal tab in (FIG. 3) using a hammer and punch.
OPERATION INSTRUCTIONS • If the operator is not fluent in English, the product and safety instructions shall be read to and discussed with the operator in the operator's native language by the purchaser/owner or his designee, making sure that the operator comprehends their contents.
MAINTENANCE INSTRUCTIONS • Maintain your equipment. It is recommended that the general condition of any equipment be examined before it is used. Keep your equipment in good repair by adopting a program of conscientious repair and maintenance. Have necessary repairs made by qualified service personnel. • Follow the maintenance instructions carefully to keep your equipment in good working condition. Never perform any maintenance on the equipment while it is under a load. a.
ASSEMBLY DIAGRAM Item Part# Description Qty 1 T43002C-1 Ratchet bar 1 2 T43002-4 Locking pawl 1 3 GB879-4x30 Spring pin Ø4x30mm 1 4 T42002-7 Locking handle 1 5 T42002-6 Handle sleeve 1 Base frame 1 Safety pin assembly 1 6 7 T46002C-3 (ASM) Safe Operating Temperature is between 40°F – 105°F (4°C - 41°C) Page 8
NOTES Page 9
3 Ton Jack Stands with Double Lock WARRANTY 90-DAY MONEY BACK GUARANTEE This MASTERFORCE™ brand prouduct carries our 90-Day Money Back Guarantee. If you are not completely satisfied with your MASTERFORCE™ brand prouduct for any reason within ninety (90) days from the date of purchase, return the tool with your original receipt to any MENARDS® retail store, and we will provide you a refund - no questions asked.
© 2010 Menard, Inc.
