Use And Care Manual

Page 9
OPERATION INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
1. MOUNTING ACCESSORIES
CAUTION
For all work or when changing
accessories, always wear protective gloves. Avoid
risk of injury from the sharp edges of the accessories.
Accessories can become very hot while working,
presenting danger of burns. Make sure the tool is
unplugged prior to changing accessories.
2. TO CHANGE ACCESSORIES
WARNING
To reduce the risk of injury, do
not let the sharp side of the accessory face
back toward the user’s hand.
NOTE: The ange will need to be completely
removed to install certain accessories that do
not have an open-ended connection interface.
The tool-less blade change lever allows you to
change the accessories without using a hex key.
• Flip the tool-free blade release lever forward
to the open position to loosen the ange. (Fig. A).
Fig. A
Fig. C
Fig. E
Open-Ended
Closed-Ended
Fig. B
Fig. D1
Fig. D2
• Insert the accessory onto the accessory
interface, then (if necessary, re-insert the
ange) press down the ange with nger to
keep the blade temporarily secure. (Fig. B)
Fig. A
Fig. C
Fig. E
Open-Ended
Closed-Ended
Fig. B
Fig. D1
Fig. D2
• Flip lever back down to seated position to
secure accessory. (Fig. C)
Fig. A
Fig. C
Fig. E
Open-Ended
Closed-Ended
Fig. B
Fig. D1
Fig. D2
NOTE: For Dremel and Porter Cable any other
brand blades, before inserting them, the adapter
should be installed rst and tted with the spare
ange. (Fig. D1, D2).
OPERATION