Use And Care Manual

Page 10
Fig. A
Fig. C
Fig. E
Open-Ended
Closed-Ended
Fig. B
Fig. D1
Fig. D2
Fig. A
Fig. C
Fig. E
Open-Ended
Closed-Ended
Fig. B
Fig. D1
Fig. D2
3. MOUNTING / CHANGING THE SANDING
SHEET
• Completely remove the ange.
• Install the sanding pad over the accessory
interface.
• Reinstall the ange.
• Align the holes of the perforated sanding
sheet with the slots of the perforated sanding
pad and press the sheet onto the pad. (Fig. E)
• Firmly press the oscillating tool with the
installed sanding sheet against a at surface
and briey switch the power tool on. This
provides for good adhesion and prevents
premature wear.
• If one point has become worn after use,
pull off the sanding sheet, turn it 120°, and
re-install.
Fig. A
Fig. C
Fig. E
Open-Ended
Closed-Ended
Fig. B
Fig. D1
Fig. D2
4. OPERATING THE ON/OFF SWITCH
• Switching the power tool on: slide switch
forward.
• Switching the power tool off: slide switch
backward.
5. USING THE VARIABLE SPEED DIAL
Select oscillation frequency (speed) while
the motor is running. The variable speed dial
can be used to set the optimum oscillating
frequency according to the accessories used
and the respective application.
High oscillation frequency
Sanding, sawing, rasping and polishing stone
and metal.
Low oscillation frequency
Scraping, polishing varnishes.
6. LED LIGHT
The LED light allows you to keep a clear view
under less illuminated circumstances. To turn
on the light, simply press the on/off switch.
When you release the on/off switch, the
light will turn off.
7. CONSTANT SPEED
Your tool is equipped with an internal constant
speed control system which helps keep the
preselected speed virtually constant between
no-load and load conditions.
OPERATION