Use And Care Manual

Page 23

FIG. 15a

FIG. 15b

BEVEL CUTTING (ANGLE CUTTING)

(Fig. 15a-15b)

• Lay out or secure design to workpiece.

• Move the drop foot to the highest position by loosening

the drop foot lock knob. Retighten the drop foot lock knob.

• Tilt the table to the desired angle by loosening the bevel

adjusting knob (A) to move the work table to the proper

angle using the bevel scale (B) and the bevel indicator (C).

• Tighten the bevel adjusting knob (A).

• Loosen the screw (D) with 5 mm hex key, and tilt the drop

foot (E) to the same angle as the work table. Retighten the

screw.

• Position the workpiece on the right side of the blade.

Lower the drop foot against the surface by loosening the

drop foot lock knob. Retighten the drop foot lock knob.

• Follow steps 5-7 under “Freehand Cutting”.

OPERATION