Use And Care Manual

FIG. 8d

FIG. 8e

ASSEMBLY

Page 17

PINLESS BLADE (NOT INCLUDED)

(Fig. 8a, 8d-8e)

CAUTION: when blade is too tight or not installed, it may viberate.

To remove a blade:

• Open the blade guard upward.

• Loosen the blade tension by pushing the blade tension

knob (A) up. (Fig. 8a)

• Turn the bevel adjustment knob (G) clockwise to tilt the

work table until it is 45° left.

• Loosen the upper blade screw (H) and lower blade clamp

screw (I) with 2.5mm hex key supplied.

• Lift the saw blade (B) out by pulling forward on blade, then

lift the blade from the upper blade holder (C) and lower

blade holder (D). A slight downward pressure against the

upper arm (E) may be helpful when removing blade from

upper blade holder.

To install a blade:

• Place the new blade through the opening in the table

insert with the teeth to the front of the saw and pointing

down toward the work table.

• Keep the new blade (B) in the recess of the lower blade

holder (D).

• Gently tighten the lower blade clamp screw (I).

• Pull up on the blade, press down on the upper arm (E)

and position the upper end of the blade in the upper

holder (C).

• Gently tighten the upper blade clamp screw (H). Make

sure the blade is properly located in the blade holders.

Tighten both the upper and lower clamp screws.

• Push down the blade tension knob (A).

• Adjust the blade tension by turning the blade tension knob.

Turn it clockwise will increase blade tension and turn it

counterclosewise will reduce blade tension.

• Close the blade guard downward.

• Turn the bevel adjustment knob (G) anti-clockwise to tilt the work table until it is 0°.

CAUTION: adjust the blade tension after push down the blade tension knob. If not, blade may be broken.