Use And Care Manual

Page 14

ASSEMBLY

CAUTION: When cutting at angles, the drop foot

should be tilted so it is parallel to the work table and rests

at against the workpiece. To tilt the drop foot, loosen screw

(B) with 5 mm hex key, tilt drop foot to the proper angle,

then retighten screw (B).

FIG. 6a

FIG. 6b

FIG. 6c

SQUARING THE WORKING TABLE TO

THE BLADE (Fig. 6a-6c)

• Open the blade guard (A) upward.

• Loosen the screw (B) and remove the drop foot (C).

• Loosen the bevel adjustment knob (D) to tilt the work table

until it is approximately perpendicular or at right angle to

the blade.

• Place a right angle ruler (E) on the work table (F) next to

the saw blade (G).

• Loosen the screw (H) holding the scale indicator (I). Move

indicator to the 0° mark and securely tighten screw.

Remember, the bevel scale (J) is a convenient guide but

should not be relied upon for precision. Make practice cuts

on scrap material to determine if your angle settings are

correct.

• Replace the drop foot and tighten the screw (B).

• Close the blade guard (A).