Use And Care Manual

Page 13

ASSEMBLY

FIG. 3

FIG. 4

FIG. 5

DROP FOOT ADJUSTMENT (Fig. 3)

To prevent workpiece from lifting, the drop foot (A) should

be rests at above the workpiece and the drop foot adjusted

so it is parallel to the working table when angle cutting. The

drop foot should not be adjusted so that the workpiece

drags.

Always retighten the drop foot lock knob (B) after each

adjustment has been made.

DUST BLOWER ADJUSTEMT (Fig. 4)

The attached dust blower (A) is designed to direct air to the

cutting line. Adjust the dust blower to the desired position.

For the best results, always direct air ow at the blade and

the workpiece.

LED LIGHT ADJUSTEMT (Fig. 5)

Input voltage : 3.2-3.4 V

Input current: < 55 mA

• To turn On the LED light, press the “I” button.

• To turn Off the LED light, press the “O” button.

With an easy ON/OFF switch (A), the attached LED light (B)

keeps the cutting line on the workpiece lighted for more

accurate scroll cut. Adjust the LED light to the desired

position.

• To adjust, loosen the screw (C), tilt the drop foot (A) so it

is parallel to the working table, and tighten the screw.

• Loosen the drop foot lock knob (B) to raise or lower the

drop foot until it just rests on top of the workpiece. Tighten

the knob.

• Loosen the horizontal adjustment screw (D) with hex key

5mm (included), then move the drop foot forward or

backward as needed.

The tall, front part of the drop foot acts as a blade protector

to prevent accidental contact with the blade.