Use And Care Manual
Page 47
WARNING: When servicing, use only identical replacement parts. Use of any other part may create a hazard or
cause product damage.
WARNING: Always wear safety goggles or safety glasses with side shields during power tool operation or when
blowing dust. If operation is dusty, also wear a dust mask.
WARNING: Before performing any maintenance, make sure the tool is unplugged from the power supply and
switch is in the off position.
WARNING: DO NOT at any time let brake uids, gasoline, petroleum-based products, penetrating oils, etc., come
in contact with plastics parts. Chemicals can damage, weaken, or destroy plastic.
MAINTENANCE
GENERAL MAINTENANCE
LUBRICATION
• Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types
of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
• Periodically check all clamps, nuts, bolts, and screws for tightness and condition. Make sure the table insert is in good
condition and level with the working table.
• Check the blade guard assembly after performing maintenance to make sure it is installed correctly and functioning
properly.
• Clean plastic part only with a soft damp cloth. DO NOT use any aerosol or petroleum solvents.
• All of the bearings in this tool are lubricated with a sufcient amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore, no further lubrication is required.