Use And Care Manual
FIG. 25
Page 44
63
89
32
45
6
WARNING: Before performing any adjustment, make sure tool is unplugged from power supply and switch is in
off position. Failure to do so could result in serious personal injury.
The table saw has been adjusted at the factory for making very accurate cuts. However, some components might have
been jarred out of alignment during shipping. Also, over a period of time, readjustment will probably become necessary
due to wear.
Carefully check alignment with a framing square before beginning adjustments to conrm whether they are necessary. Use
test cuts after completing adjustments to avoid damaging workpiece.
CAUTION: Unplug saw. Remove blade guard and
anti-kickback pawls. Raise the blade by turning height
adjusting knob.
CAUTION: The adjustment must be correct. If it is
not, kickback could result in a serious injury and inability to
make accurate cuts.
WARNING: Rip fence must be aligned to blade so
that wood does not bind, resulting in kickback. Failure to
do so could result in serious personal injury.
Rip fence and blade alignment is set at factory and in most cases will not need to be adjusted. However, the
alignment should always be checked after installing blade or before making cuts, and can be adjusted if necessary.
If rip fence is out of alignment with blade, adjustment is needed.
Aligning rip fence to blade (Fig. 25)
DO NOT loosen any position screws for this adjustment
until alignment has been checked with a square to be sure
adjustment is necessary. Once screws are loosened, items
must be reset.
To check/adjust:
• Place the framing square (89) beside the blade (45), and
Unlock the fence rails locking lever (32) to move the rip
fence (6) up to the square.
• Lock the fence rails locking lever (32) and note the
measurement on the rip scale.
• Move the fence back and rotate the framing square (89)
180° to check the other side.
• If the two measurements are not the same, loosen the
position screws (63) on the extension poles and then align
it.
• Retighten the position screws with 4 mm hex key
(supplied). Recheck alignment after position screws are
retightened.
• Replace the blade guard and anti-kickback pawls.
• Make two or three test cuts using scrap wood. If the cuts
are not true, repeat the process.
ADJUSTMENTS