Use And Care Manual

OPERATION
Page 40
Making a miter cut
• Remove rip fence.
• Set blade to correct depth for workpiece.
• Set miter gauge to 0° and tighten lock knob.
• Make sure the wood is clear of the blade before turning on the saw.
• Turn the saw on.
• Let the blade build up to full speed before moving the workpiece into the blade.
• Hand closest to blade should be placed on miter gauge lock knob and hand farthest from blade should be placed on
workpiece. Feed workpiece into blade.
• When cut is complete, turn saw off. Wait for blade to come to a complete stop before removing workpiece.
Making a bevel cross cut
• Remove rip fence.
• Unlock bevel locking lever.
• Adjust bevel angle to desired setting.
• Lock bevel locking lever.
• Set blade to correct depth for workpiece.
• Set miter gauge to 0° and tighten lock knob.
• Make sure wood is clear of blade before turning on saw.
• Turn saw on.
• Let blade build up to full speed before moving workpiece into blade.
• Hand closest to blade should be placed on miter gauge lock knob and hand farthest from blade should be placed on
workpiece. Feed workpiece into blade.
• When cut is complete, turn saw off. Wait for blade to come to a complete stop before removing workpiece.
Making a rip cut
• Set blade to correct depth for workpiece.
• Unlock the fence rails locking lever and slide rip fence to desired distance from blade for cut.
• Lock the fence rails locking lever.
• Make sure wood is clear of blade before turning on saw.
• When ripping a long workpiece, slide the outfeed support to fully extend.
• To turn saw on, press the green “I”-button.
• Position workpiece at on table with edge ush against rip fence. Let blade build up to full speed before
feeding workpiece into blade.
• Once blade has made contact with workpiece, use hand closest to rip fence for guidance. Make sure edge of workpiece
remains in solid contact with both rip fence and surface of table. If ripping a narrow piece, use push stick and/or push
blocks to move piece through cut and past blade.
• When cut is complete, turn saw off. Wait for blade to come to a complete stop before removing workpiece.
Making a bevel rip cut
• Remove miter gauge.
• Unlock bevel locking lever.
• Adjust bevel angle to desired setting.
• Lock bevel locking lever.
• Set blade to correct depth for workpiece.
• Unlock the fence rails locking lever and slide rip fence to desired distance from blade for cut.
• Lock the fence rails locking lever.