Use And Care Manual

Page 34
FIG. 17a
FIG. 17b
OPERATION
32
79
32
78
78
79
32
CAUTION: When ripping, always lock the fence
rails locking lever.
WARNING: To reduce the risk of injury, always
make sure the rip fence is parallel to the blade before
beginning any operation.
Rip fence (FIG. 17a-17d)
Fence rails locking lever (Fig. 17a)
The fence rails locking lever locks the rip fence in
place preventing movement during cutting.
• To lock the fence rails locking lever (32), push it up toward
the front of the saw.
• To unlock the fence rails locking lever (32), push it down
toward the rear of the saw.
CAUTION: Retract the narrow fence whenever
working over the working table.
Narrow fence (Fig. 17b)
Your table saw is equipped with a narrow fence (78) to
support workpiece that extends beyond the working table.
• To use the narrow fence (78), loosen the locking lever (79)
counter-clockwise and rotate the narrow fence (78) to
position B as shown in Fig. 17b, then tighten the locking
lever.
• When not in use, loosen the locking lever (79) counter-
clockwise and retract the narrow fence (78) to position
A shown in Fig. 17b.
B
A
2
2
1
3